One of those occasions when looking for an item you come across something else purchased a while back and think I should really finish it… The other weekend I found my 3D print, purchased from Simon Dawson’s store on Shapeways (in those days when it was much cheaper than it is now…), of the 6 wheel ex SECR Diagram 1558 20 ton brake van, so I decide it would make a nice quick win project and be one less thing on the things to do one day list/pile…
Forty 6 wheel 20t brake vans were built in 1898 by the South Eastern and Chatham Railway to Diagram 1558, these had an open veranda platform (i.e. with no roof, sides or end rail) at one end and a closed one at the other. In 1910, 50 more were built with close verandas at each end, between 1914 and 1920 the original vans were modified with two closed verandas. These modified vans were identifiable as had double top rails at the rebuilt end only. All 90 vans entered Southern Railway stock and most passed into British Railways ownership. There were also variations in some of the framing, planking and handrails between the two built versions.
The one piece 3D print represents one of the first batch as modified with both verandas enclosed and correctly has the double end top rails at one end only. The print is pretty basic but was quite a clean print, has no floor, and is missing some of the fine top corner strapping detail. Handrails and lamp irons are thankfully not part of the print as I would have replaced these if they were. I replaced the printed bufferheads with finer turned metal 13″ versions, drilling the buffer stocks to take the shank.
There is no representation of any brake gear, although its omission is mainly hidden behind the full length stepboards, I will at some stage add some brake gear, once I purchase some suitable etches.
I drilled the axle boxes to take standard brass top hat bearings for Alan Gibson 12mm spoked wheels, wire handrails and lamp irons fashioned from Bambi staples were added. I made a floor from plasticard onto which I added some lead strip to bring the van weight up to approx. 45g to ensure good running. To affix the floor I first glued some plastic ‘T’ section to the inside of the van sides to provide a mounting location.
Following a dust of Halfords plastic primer the van was brush painted with Precision Paints P91 SR Freight Brown and P90 SR Venetian Red for the ends. Lettering and numbers were added using HMRS Pressfix SR Wagons transfer sheet 13 and then give a spray coat of Railmatch satin varnish to seal. Glazing for the end windows was glued into place before the floor was affixed.
For the time being standard slim tension lock couplings have been fitted using Peco Parkside P34 mounting blocks. It is now added the queue of items to be weathered.
I am sure there is potential for these vans to become a ready to run model one day, as interest in pre-grouping rolling stock is on the increase, hence this project being done as a bit of quick win.
There used to be one of these, or something similar, on KESR
Hi Dave, yes it is still there.
Very nice – so good to learn about making the 3D models into the finished item – thank you.
How does it run? After some 6 wheel disasters a few years back I am cautious although I very much like the appearance.
Hi Barry, it runs quite happily through all the short radius point work on Canute Road Quay, being quite a short wheelbase it’s not a problem.